For my school project, I decided to create Kirby in TinkerCAD. The new game "Kirby Triple Deluxe" is coming out on May 2nd, so I decided It would be cool to create him in 3D!
First off, you get a sphere from the sidebar and put it on the work space. Then go to the color section and color it pink.
Get 2 paraboloids out of the sidebar and put them in the workspace. Then go to the color section and color them pink too.
Next get 2 half circles from the sidebar and put them on the workspace. Go to the color section and color the half circles red.
Stretch each half circle out to 45mm long. Put the 2 half circles at the bottom of the big pink circle equally on each side of the circle.
Get the 2 paraboloids and raise them both up to 30mm. Put them on either side of the pink circle and rotate them to 90 degrees. Move the paraboloids closer until they are moved into the pink cirlce.
Get 2 circles from the sidebar and put them in the workspace. Go to the color section and color them black. Make them 19.40mm tall and 1mm flat. Move them up to 38mm and move them closer to the front of the circle.
Get 2 half circles from the sidebar. Squeeze them down to 1mm and go to the color section and color them white.
Make the 2 flat circles 1mm thin, 1mm wide, and 2mm tall. Put the 2 cirlces back on the workplane.
Get a round roof from the sidebar and put it on the workplane. Rotate the round roof 180 degrees.
Move the 2 white circles to the top of each of the black ovals. Make the round roof's length 1mm and color it magenta.
Move the round roof in between the 2 black ovals. Then, move it as close to the pink circle as you can before it goes into it.
Finallly, admire the finished product! I think I got pretty close. Compare how well you did to the actual picture!
Now that I finished Kirby, I am going to make his friend Waddle Dee!
Go to the sidebar and get a sphere. Make it 64mm wide, tall, and long. Then color it red.
Go to the sidebar and get 2 half cirlces. Put them on the workplane.
Stretch the 2 half circles out to 20mm, then put the on either side of the red cirlce. Color them beige.
Rotate the half cirlces 20 degrees, then get 2 paraboloids from the sidebar. Put them on the workplane.
Color the 2 paraboloids red and rotate them 90 degrees one facing left and right. put them on either side of the red circle.
Go to the sidebar and get 2 half circles. Put them in the workspace and color them beige.
Flatten out the 2 half circles to 1mm. Rotate them 90 degrees upwards and sideways.